Care & Maintenance

Care, Cleaning, Storage and Transport

July 12, 2026 Marius Schober 1 min read

Keep components flat, dry and protected from impact.

Do not open or service hardware.

Pay attention particularly if installed within a sports floor, the Movetrics F1-3D force plate must never be wiped wet.

Procedure

  1. Finish: Save required notes and files and close Movetrics Studio normally.
  2. Disconnect when required: Switch off according to the installed procedure and handle plugs by the connector body.
  3. Clean: Use only approved cleaning products and methods for the installed surfaces.
  4. Dry: Do not pour or spray liquid directly onto boards, connectors or the acquisition box.
  5. Store: Keep boards flat and protected from impact; route cables without sharp bends or loads.
  6. Transport: Use the approved protective packaging and prevent loads on board surfaces or connectors.

Stop or repeat when

  • Liquid enters a component.
  • A housing, fastener, cable or connector is damaged.

Important: Do not open housings, adjust fasteners, apply lubricant, repair cables or perform calibration of Fx and Fy. Record damage and contact Movetrics Support.